Starter strips bottom side have a cellophane protective strip that touches the metal drip edge.
Roofing protective cellophand strip.
Zincshield pure zinc strip to avoid ugly roof stains from moss algae fungus and mildew 50 foot roll 2 5 includes bag of zincshield nails made in the usa.
The zinc strip is installed along both sides of the ridge of the roof so that most of the strip is exposed.
Because the cellophane strips have no effect on the performance of asphalt shingles it s fine to leave them in place as you install the shingles.
Zinc protect roof strip for moss and mildew prevention 2 5 wide and 50 long zinc strip.
Every time it rains some of this zinc oxide leaches down the roof inhibiting the growth of moss and mildew.
A superior alternative to starter shi.
Nails are 3 inches from the edge of the starter strip.
The exposed zinc will oxidize forming zinc oxide.
Very large roofs may require extra protection.
But we don t want them to stick together in the package so a protective strip is stuck to the bottom of the shingle just lined up with this adhesive strip when they are stacked in a package.
Cellophane release strip on asphalt shingles and my reasons to remove it when appling singles to a roof.
In order to navigate out of this carousel please use your heading shortcut key to navigate to the next or previous heading.
Filmed october 29 2014.
When you spread them out on the roof the strip does not line up with the adhesive so it does nothing and the adhesive can do its job.
It sounds to me from what you are describing that the strip stuck to the glue strip when the roofer separated the shingles during installation.
If the cellophane strip is on the back of the shingle it is fine.
The cellophane release tape lines up with the adhesive strip on the shingle below it in the bundle to keep the shingles from sticking together.
Gaf mastering the roof chapter 09 this video demonstrates the proper installation technique for gaf starter strips.
Is it ok using liquid nails fuze it at this 3 inch area will where the glue is on the metal drip but the glue is also touching the cellophane protective strip on the underside of the starter strip.